direction for stm32 ARM cortex-M0 building. Also adding more explicit
error message if VID/PID of device found, but unable to open due to
drivers not being installed.
Got quite a bit done since last commit, and never committed all the
changes. Most should be fine but need to review a little more before
I'm ready to commit those. Mostly was in a rush to get SF2 working and
then took a break before cleaning up and committing progress.
Once old SF2/SNES STM8 updates committed, need to move on to supporting
NES mappers. Also in a bit of a rush to verify new STM8S001 can be
programmed via CIC CLK on inl6 devices. Also need to get JTAG up and
running to make progress on SNES v2 board design.
Figured out problem with STM32F070 bootloader, basically broken for
16Mhz crystals because ST doesn't do adequate testing on their
bootloader code to verify datasheet and AN specs of allows xtal
frequencies. 4, 8, 12, & 24Mhz tested and working, also STM32F072
works. Have dumped bootloader and started analysis. STmicro isn't
offering any help to fix issue, bunch of jackasses! Oh well, plan is to
establish my own bootloader means which has benefit of allowing me to
define however I'd like. Planning on LED pin held high triggering
bootloader which would require smallest erase/write protected sector to
be devoted to my bootloader similar to how things were done for AVR.
After detecting bootloader, initialize HSE and jump to ST's bootloader
code so don't have to write my own USB drivers for the bootloader alone.
Paul XPS