-Updated STM devices to always run @ 48MHz
Doesn't seem to cause any problems with SNES flashing couple thousand SF2
boards have been flashed with this build without issues
-Added note to usb_operations.c as manf/prod ID can't be read if drivers
aren't installed. Caused issues for Todd as he hadn't installed drivers
for new hardware.
-STM swim operations are working pretty well for SNES v2 and v3 boards
Haven't even touched SWIM on AVR core yet...
SWIM is pretty pin independent but only implemented on EXP0 so far
Reads "ROTF" aren't bullet proof but they're pretty good. Biggest
room for improvement aside from adding a legit pullup would be to have
an interrupt trigger the device header bit falling edge instead of the
current polling method which has decent amount of jitter.
Implementing interrupts would also probably allow for more easily
supporing reads longer than a single byte...
Only reads one byte, but good enough.. to get things done.
Code should actually work for low and high speed, but have only tested
high speed on writes so far.
Having issue where reads can fail at times. Esp with long strings of
'0'.. Perhaps operating at high speed would improve matters..
Although I'm also realizing maybe I'm not waiting for the device to reset
and reload HSI trim factory value, need to check that..
The new assembly file/function does everything needed so can start cutting
out inline assembly from swim_out function.
Swim code needs to run at 48Mhz. Realizing this is pretty vital to having
enough time to handle high speed. And timing of artificial pull-up
requires high trimmability..
Paul Molloy