0dd8828744
-Updated STM devices to always run @ 48MHz Doesn't seem to cause any problems with SNES flashing couple thousand SF2 boards have been flashed with this build without issues -Added note to usb_operations.c as manf/prod ID can't be read if drivers aren't installed. Caused issues for Todd as he hadn't installed drivers for new hardware. -STM swim operations are working pretty well for SNES v2 and v3 boards Haven't even touched SWIM on AVR core yet... SWIM is pretty pin independent but only implemented on EXP0 so far Reads "ROTF" aren't bullet proof but they're pretty good. Biggest room for improvement aside from adding a legit pullup would be to have an interrupt trigger the device header bit falling edge instead of the current polling method which has decent amount of jitter. Implementing interrupts would also probably allow for more easily supporing reads longer than a single byte... |
||
|---|---|---|
| .. | ||
| blank.lua | ||
| buffers.lua | ||
| cart.lua | ||
| dict.lua | ||
| dump.lua | ||
| erase.lua | ||
| flash.lua | ||
| nes.lua | ||
| snes.lua | ||
| swim.lua | ||
| usb_device.lua | ||